1-1/2" x 16 Ga. RUESCH, Flying, 32" Carriage Travel, 500 FPM, Entry & Exit Guides

UTREC NUMBER:    457
MANUFACTURER:    RUESCH

SPECIFICATIONS:
Single Blade, Dimple Type Flying Cut-Off for use with a Tube Mill

Material:            1/4" - 1-5/8" Diameter Hard Drawn Copper
Blade:               1/16" Thick x 2" Wide
Cut-Off Cylinder:    Hydraulic, 3" Diameter x 6" Stroke
Carriage Travel:     32"
Maximum Mill Speed:  500 FPM
Tooled for 15/16" Diameter
Hand of Operation:   Right to Left
Carriage Acceleration & Return via Twin Chain & Air Clutch
 Chain is Variable Speed
 Carriage runs on Twin Thompson Shafts, 2" Diameter

EQUIPPED WITH:
  Entry & Exit Guides
  Air Over Oil End of Stroke Cushions (Both Directions)
NOTE:  Missing Hydraulic Unit.  Requires 80 PSI Air.