1/2" YODER #W15, ERW, Reducing Mill, 9 Driven Stands, 2,500 Lb. Dbl. Uncoiler, For Refrigeration Tube

UTREC NUMBER:   1166
MANUFACTURER:   Yoder Manufacturing Co. 
MODEL NUMBER:   W15 Forming - W15 Reducing
SERIAL NUMBER:  Y1352-62
REBUILT IN 1983

SPECIFICATIONS:
Type:  Refrigeration Mill
Hand of Operation:  Left to Right

This machine was used to manufacture refrigeration tubes that must be
 reduced to increase length and maintain wall thickness. 

The tube is welded at .480" and reduced to smaller sizes

Welding Speed:   125 FPM
Reducing Speed:  275 FPM @ 3/16" (4.7mm)
                 200 FPM @ 1/4" (6.3mm)
                 150 FPM @ 5/16" (7.9mm)

ENTRY EQUIPMENT:
2,000 Lb. (1 Ton) Gantry Crane
2,500 Lb. (1.2 Ton) Double Uncoiler
Overhead Looper 2 Strand, approximatly 300 Feet Storage 
Shear End Welder
Pinch Roll Pull Out Stand, 10 H.P.

FORMING MILL:
Entry Guide Unit
3- Driven Breakdown Stands
2- Driven Fin Passes
4- Idle Side Roll Units
1- Seam Guide Unit
1- 18,000 Amp.D.C. Welder Rotary Resistance
1- Scarfing Unit
1- Coolant Section
1- 20 H.P. D.C. Motor

REDUCING (Sizing) MILL:
9- Driven Reducing Stands
9- Idle Side Roll Units
1- Straightener Stand
9- 7.5 H.P. D.C. Motors

1- Dual Pass Annealer Section with Cutler Hammer Controls

1- Tube Coiler with Cut Off Machine

D.C. DRIVE SYSTEM:
1- Walco Solid State D.C. Drive System, with Culter Hammer Controls
   Voltage 380/3/50

Tooling to produce the following Sizes:
3/16" (4.7mm) - 1/4" (6.3mm) - 5/16" (7.9mm) 
All Produced From 1/2" Welded Tube

Replacement Cost for a New Machine is approximately  $1,900,000.