1-1/2" YODER W-15 Tube Mill

UTREC NUMBER:  1514
MANUFACTURER:  YODER
MODEL:         W15
AGE:           1967

SPECIFICATIONS:
  Max. Tube Diameter:              1-1/2"  (38 mm) 
  Min. Tube Diameter:              .500" (12.7 mm)
  Max. Wall Thickness:             .083"  (2.1 mm)
  Min. Wall Thickness:             .018"  (0.5 mm)
  Max. D/T Ratio:                  60:1
  Min. D/T Ratio:                  10:1
  Max. Material Yield:             50,000 PSI
  Max. Mill Speed:                 400 FPM  (120 MPM)
  Roll Space (Width) Forming:      15" (381 mm)
  Roll Space (Width) Fin & Sizing: 15" (381 mm)
  Driven Spindle Diameter:         1-1/2" (38 mm)
  Hand of Operation:               Left to Right

ENTRY EQUIPMENT:
  1- Double 5,000 Lb. BRONX HS Uncoiler w/Pneumatic Brake
  1- Shear End Welder w/Manual Operation
  1- Kent Floop Model No. R-151, Rebuilt by Kent 2001, 700 FPM Fill Speed

FORMING MILL- 30HP D.C. Motor
  1- Entry Guide Unit w/2 Edge Trim Tools
  3- Driven Breakdown Stands
  6- Idle Side Roll Units
  3- Driven Fin Stands

WELDING SECTION:
  1- THERMATOOL/INDUCTRON 300KW / 400 KHz High Frequency Welder, 1987. S/N C-8711269
  1- Seam Guide Unit
  1- Weld Pressure, 3-Roll Type
  1- Scarfing Unit
  1- Bead Winder

COOLANT SECTION:
  1- 20' Coolant Zone, Flood Type
                                                                            
SIZING MILL, 60 H.P. DC Reliance Motor and Drive, 850/2400 RPM
  3- Driven Sizing Stands w/Single Point Adjustment
  3- Idle Side Roll Units
  1- Straightener Unit (Modified Turkshead)

CUT-OFF PRESS:
  1- ALPHA Flying Cut -Off, Double Cut Model SR-10-2-55, 1988, S/N 6K73-389,
     2.5" X .134" (63.5 X 3.4mm)
     Capacity: 2" x .120",  Hydraulic Clutch, 400 FPM, Digital Die Accelerator 
     System - "Closed Loop Measuring System"
  1- 20' Run Out Table

TOOLING:
  2- Sets of Rolls Will Be Included

CONDITION: GOOD, Under Power United Kingdom Location