1" (25.4mm)x .065 (1.65mm) T & H #WU-11M-12 w/In-Line Anneal

UTREC NUMBER:  1611
MANUFACTURER:  TUREK & HELLER
MODEL NUMBER:  WU-11M-12
SERIAL NUMBER: 1299
AGE:           1996


SPECIFICATIONS:
Maximum Tube Diameter:    1" (25.4mm)
Minimum Tube Diameter:    .375" (9.53m)
Maximum Wall Thickness:   .065" (1.65mm)
Minimum Wall Thickness:   .010" (0.25mm)
Material:                 All TIG Weldable Alloys
Roll Space:               4" (101.6mm)
Driven Spindle Diameter:  1.125" (28.5mm)
Roll Root Diameter:       2.250" (57.1mm)
Hand of Operation:        Left to Right
Line Speed:               40 Feet Per Minute, Gear In

ENTRY:
 1 - LITTELL 4,000 Lb. Uncoiler
      Model: 40-12
      S/N:   87-695-84
      12" Wide x 60" O.D.

FORMING MILL:
  1 - Strip Entry Guide
  4 - Driven Breakdown Stands
  3 - Idle Side Roll Units
  3 - Driven Fin Stands
  3 - Idle Side Roll Units

WELDING SECTION:
  Weld Pressure Unit - 4 Roll
    Cyclomatic Arc Control
    Atmosphere Enclosure (Argon-Helium)
  INTELLITIG 40 Welder
  Coolant Zone
  2 - COOLMATE Cooling Units
  MAC Eddy Current Tester Model No. 30

SIZING MILL:
  1 - Dual Head Bead Flash Grinder
  1 - Tranducer Wheel
  3 - Driven Sizing Stands
  4 - Idle Side Roll Units
  1 - 2-Roll Straightener

BRIGHT TUBE ANNEALING SYSTEM:
 1 - LEPEL INDUCTION Annealer 100 KW
      S/N: 7413-7503
     With EVAPCO Closed Loop Cooling System

PULL OUT:
 2 - Driven Stands
 3 H.P. D.C. Drive System

FLYING ABRASIVE CUT OFF SAW w/Digital Length Control System:
  Saw Blade Diameter: 8"
  Saw Motor: 2 HP
  D.C. Accelerator System, RELIANCE Flex Pak
  36" Travel
  20' Runout Table

MILL DRIVE:
  2 - 7-1/2 HP DC Motor, Forming/Sizing
  RELIANCE Max Pak III D.C. Drive System
  RELIANCE Automate Programable Controller
 1 - 3 H.P. D.C. Motor, 2 Stand Pull-Out

TOOLING:
 1 - Set of Rolls - .375" (9.53mm) On the Mill

Condition:  Good As Taken From Service