For info:
Rotary Boring Reaming Tapping and Threading Machine SPECIFICATIONS: (3) Tapping Heads M.D. 5/3 HP. 2-Speed, 3 Phase, 60 Cycle 440 Volt (6) Drill Heads M.D. 5/3 HP. 2-Speed, 3 Phase, 60 Cycle 440 Volt (1) Bar Cutter and Loader (1) Chip Conveyor Complete Free Standing Electical Control Cabinet with Individual Controls for the following: Left Front Spindle (Left Reamer) Upper Center (Not Used/Empty Station) Right Front Spindle (Right Reamer) Left Rear Spindle (Left Spot Facer) Left Middle Spindle (Left Thru Drill) Top Spindle (Ballseat Drill) Lower Center (Not Used/Empty Station) Right Rear Spindle (Right Spot Facer) Right Middle Spindle (Right Thru Drill) EQUIPPED WITH, Oil Pneumatic Driven 8-Station Turret Transfer System. For Work with Rack and Pinion Drive and Positive Lock/Locator Systems. The Machine is Designed to Accommodate a Total of Nine Working Spindles. There are Presently Seven Working Spindles on the Machine as Described Above. Machine Mounted Operator Control Station for Automatic Cycle. Semi-Automatic Cycle, Manual Cycle, Power On, Speed, Turret Indexing, Locked Turret, Units Feed In, Units Feed Out, Stop and Feed Out, Chuck Opening, Brake Release, Chip Conveyor, Coolant Pump, Machine Mounted Dual Palm Buttons for Cycle Stan. Machine Mounted E-Stop, Jorgensen 12" Wide Motor Driven Slat Type Chip Conveyor. M.D. Coolant System. Work Light. Manuals and Drawings. Spindle Stroke 5" Rapid Feed Rate (In/Out) 300 IPM Working Feed Rate 0 - 80 IPM Spindle Nose IS040 Condition: Good