For info:
Right to left mode of operation Coil Car 30,000# capacity L-Type design, floor standings Self enclosed hydraulic power unit Pendant control 72" OD Uncoiler 30,000# capacity 20" ID x 67" face mandrel Hydraulic expansion Side Base Hydraulic power unit Entry Unit Fully articulating peeler table Driven hold down roll Slitter 6" diameter x 62" face arbors Entry pinch rolls. 6" diameter x 70" face Entry side guides Parallel arbor adj. through Duft Norton Jacks Fixed base Two - 30 HP AC vector motors with new Baldor vector drives 230v/460, 1780 rpm 4000 rpm max (Each motor drive one arbor) 64 - .250" thick x 11.25 OD knives Full complement of spacers and rubbers Cross Over Table Scrap Winder Hydraulic driven Oscillating level wind 12" w x 35" od spool Tension Stand Entry tooling bar 62" wide drag board Air actuated Exit 8.5" diameter billy roll Recoiler 30,000# capacity 20" diameter x 69" face drum Manual grip & expansion Attached over arm separator Self enclosed hydraulic power unit 50hp AC vector motor, 230v/460, 1160 rpm 3000rpm max, with 60hp Allen Bradley vector drive New reducer 20.41:1 ratio 86 rpm out 16" diameter pulley from reducer to 8" diameter aprox. at the motor Turnstile 30,000# per arm Manual rotation No push off 16" ID min x 66" wide 6.25 w x 10" diameter channel for c-hook use 57" from floor to top of arm Hydraulics Electrics including operators station