60" X 7.50" X 50,000# PRO ECO SLITTING LINE

-MATERIAL:  COLD ROLLED STEEL, GALVANIZED OR EQUIVALENT
-SHEAR STRESS:  50,000 PSI
-COIL WEIGHT:  50,000 LBS.
-COIL WIDTH:  60"
-COIL O.D.:  72"
-COIL I.D.:  IN - 20" TO 24"
             OUT - 20"
-GAUGE RANGE:  .010" - .250"
-LINE SPEED:  CONSTANT - 200 / 650 FPM
              BUILDUP TO 1000 FPM
-LINE DIRECTION:  RIGHT TO LEFT

NOTE: LINE WAS RECONDITIONED IN 2000

CONSISTING OF THE FOLLOWING:

-ENTRY L-TYPE COIL CAR:
  SCISSORS LIFT TYPE
  SELF CONTAINED HYDRAULICS

-UNCOILER:
  HYDRAULIC EXPANSION
  4 LEAF PUMPKIN TOOTH MANDREL
  SLIDING BASE
  ATTACHED POWERED HOLDDOWN ROLL
  3 HP AC FEED UP MOTOR
  WATER COOLED BRAKE
  OUTBOARD SUPPORT

-EDGE CONTROL

-ENTRY UNIT:
  HYDRAULIC ACTUATED PEELER TABLE
  HYDRAULIC COIL BREAKER ROLL
  DRIVEN PINCH ROLLS
  HYDRAULIC EDGE GUIDE UNIT
  EXIT PASSLINE ROLL & CARRY OVER TABLE

-SLITTER HEADS:
  (2) - CRANE REMOVABLE HEADS
  7.50" DIA. ARBORS WITH .250" & .500" KNIVES
  TOP ARBOR ECCENTRIC HEADS
  PARALLEL TOP ARBOR ADJUSTMENT
  MANUAL OUTBOARD HOUSING
  SCRAP GUIDES
  150 HP DC MOTOR W/SOLID STATE DRIVE (BOTH NEW IN 2000)

-SCRAP WINDERS:
  (2) WINDERS WITH AUTO DUMP
  HYDRAULIC OSCILLATION

-LOOPING PIT

-TENSION STAND
  ENTRY CASCADE ROLLS
  HYDRAULIC PIT TABLE ATTACHED TO TENSION STAND
  DRAG WIPE TENSION STAND
  ENTRY SEPARATOR BAR
  IDLER EXIT PASSLINE ROLL

-EXIT CROP SHEAR:
  HYDRAULIC DOWN CUT DESIGN
  STRAIGHT BLADE TYPE
  EXIT NEOPRENE COVERED PASSLINE ROLL
  CARRY OVER TABLE TO RECOILER

-RECOILER:
  20" DIA. DRUM W/BOLT-ON PLATES TO 24" (NEW DRUM IN 2000)
  HYDRAULIC GRIPPER & EXPANSION
  ATTACHED OVERARM SEPARATOR
  HYDRAULIC PUSHOFF
  150 HP DC MOTOR, 1750/2100 RPM, 500 V
  SOLID STATE DRIVE (NEW IN 2000)

-EXIT TURNSTILE:
  (2) ARMS
  C-HOOK TYPE ARMS, 7.5" WIDE OPENING
  HYDRAULIC ROTATION
  HYDRAULIC PULLER PLATE

-LINE IS INSTALLED AND UNDER POWER UNTIL FEB. 24th 2007