7.8" diameter Eisele VAL560NC, fully auto, CNC Control, 22" carbide blade, special 17.4/22.8 HP motor, material separation, spray mist (1999)

Used EISELE MODEL VA-L 560 NC STANDARD
Fully Automatic Saw for Non-Ferrous Material
(1999)
Stock No: 7143

The Eisele Model VA-L 560 NC1 is a specialized, automatic cut-off system for aluminum extrusions, bars and tubes as well as for other non-ferrous material such as plastic and glass composites and copper and brass tubing.  The automatic material feed operates with a shuttle vise driven by a precision ball screw using a special drive motor that advances the material to a preset cut-off length with a maximum shuttle stroke up to 1000mm.

The floating shuttle vise feeds the material into the saw's two main vises.  These vises grip the material on each side of the saw blade.  The right hand vise releases immediately after the cut is made and before the blade retracts, leaving an excellent finish that is free of marking by chips and blade.

The double clamping system in pneumatic, and the infinitely variable power feed of the saw head is controlled by an air/hydraulic system.  Cooling and lubrication on both sides of the saw is provided by a spray mist coolant system, synchronized with the downstroke of the saw head.

Capacity:
Round tubes:	7.8"	Square tubing:  6.6"x 6.6"	Rectangle:  11.8" x 5.9"

Specifications:
Sawblade Dimension:	560 mm (22") Carbide tipped
Sawblade Motor:	17.4 / 22.8 HP 
Sawblade Speeds:	6335 / 12670 sfm
Electrics:  		460 volt, 3 phase
Air pressure required: 100 PSI
Dimensions: 		4' x 6' x 8'    
Weight:  		2,200 lbs.

Features:
"	NC Controller for setting length and number of pieces
"	Special heavy duty saw motor (17.4 / 22.8 HP) for solid billet
"	Heavy duty saw head double shaft design travels on a pivot center of cast iron construction
"	Hydra-pneumatic system with infinitely variable feed adjustment
"	Double spray mist coolant system
"	Complete saw blade guarding
"	Enclosed full electric over and under load voltage protection
"	Chip ejection chute for effective chip removal from sawing area
"	Automatic part separation to eliminate to avoid marking material
"	Noise reduction enclosure
"	Quick change vise jaws