16" OME Pipe Mill, TIG Weld

SPECIFICATIONS:
	Manufacture:			OME, Italy		Driven Roll Shaft Dia:	5"
	Manufacture Date:		1988			Forming Motor:			87 KW
	Hand of Operation:		Right to Left	Sizing Motor:			87 KW
	Max. Pipe Dia.:			16"				Forming Type:			Cage Breakdown
	Min. Pipe Dia.:			6"				Max. Mill Speed:	      15 FPM as geared
	Max. Wall Thickness:	.260			Sizing Type:				Conventional
	Min. Wall Thickness:	.100                    
																	
UNCOILER:
	Outboard Support Type			Sliding Base
	Max. Coil Width:	56"			Drag Brake
	Max. Coil Dia.:		72"			Hydraulic Hold Down Driven
	Max. ID:			24			Peeler - Under
	Min ID:				16			Max. Coil Wt:	30,000 Lbs.
	
FLATTENER:	Entry Pinch Roll 8" Dia. w/ Hyd. Quick Lift
				7 Roll Flattener, 5" Roll Dia. x 61" Face
				5" Roll Dia.
				61" Face or Roll
				Single Point Adj. Motorized or Manual
				Edge Guide Roll - Entry, Manual Adjustment 

EDGE TRIMMER:	Max. Strip Width:	61"
					Single Point Adjustment
					(2) Powered Scrap Winders




SHEAR END WELDER:	Hydraulic Shear Dual Cylinder
						Hydraulic Clamp Station
						Dancer Arm & Support Table

FORMING MILL ENTRY:		7 Roll Flattener
							Max. Strip:	52"
							Roll Dia.:	5"
							Entry Guide Station 4-Roll Manual Adj.

FORMING MILL: "Cage Type"
	12 - Forming Breakdown Stands
	Single Point Adj. Motorized or Manual
	9 - Idle Side Roll Units
	3 - Driven Fin Passes
	3 - Idle Side Roll Units

WELDING SECTION:	1 - Lead Roll Seam Guide Unit
						1 - 3 Roll Weld Pressure Unit
						2 - S10-AS  500 Amp Welding Power Supplier
						Complete with Flux Recovery Vacuum System 

SIZING MILL:		3 - Driven Sizing Stands
					3 - Idle Side Roll Units
					1 - Idle Turks Heads 4-Roll

SQUARING MILL:	4 - Idle Squaring Turksheads

FLYING SAW "FRICTION TYPE":
	1 - Kaltenbach Saw
		HDM 1300
		S/N 20181
		13X2845
		Travel Length 21'
	1 - Double Dump Run-Out-Table 40' Max.

TOOLING:	6" - 8" - 10" - 12" - 14" - 16"  Round