For info:
SPECIFICATIONS: Maximum Tube Diameter: 3.0" (76.2 mm) Minimum Tube Diameter: .500" (12.7 mm) Maximum Wall Thickness: .125" (3.1 mm) Minimum Wall Thickness: .018" (.46 mm) Maximum D/T Ratio: 60:1 Minimum D/T Ratio: 10:1 Maximum Material Yield: 50,000 PSI Maximum Mill Speed: 300 FPM (91 M) Roll Space Forming: 10" (254 mm) Roll Space Fin & Sizing: 5" (127 mm) Roll Root Diameter: 4.75" (120.6mm) Driven Spindle Diameter: 2.00" (50.8 mm) Hand of Operation: Right to Left Date of Manufacture: Abbey Mill - 1972, Installed 1974 Induction Welder - 1973, Rebuilt 1988 Mill Speeds @ 1800 RPM, with Drive All Shift Boxes: RATIO MILL SPEED 2.778:1 103 FPM (31M) 1.883:1 152 FPM (46M) 1.267:1 220 FPM (67M) .943:1 296 FPM (90M) Spur Gear Ratios in Breakdown Stands: (#1) 1.4:1, (#2) 2.0:1, (#3) 2.5:1 ENTRY EQUIPMENT: 1 - Littell 4000 Lb. Uncoiler, 60" O.D. X 16"-20" I.D. Model 40-12 1 - Shear End Welder, Complete Self Contained 1 - Overhead Looping System, Four Strand, 800 Ft. of Strip Storage 1- Pinch Roll Pull out Stand FORMING MILL: 1 - Entry Guide Unit 3 - Driven Breakdown Stands, with transmissions 4 - Idle Side Roll Units (Cluster unit, 4 pass) 2 - Driven Fin Stands, with transmissions 1 - Idle Side Roll Unit 1 - 40 HP DC Motor and Reliance Electrical contols, 1150/1800 RPM 1 - Drive All 4 Speed Shift, Model #DAS4, Box directly coupled to Drive Motor 1 - Operators Control Station WELDING SECTION: 1 - Seam Guide Lead Roll 1 - (4) Roll Weld Pressure Unit 1 - Single Scarfing Unit 1 - Bead Winder 1 - Inductron, 200 KW, High Frequency Induction Welder, single tube type. COOLANT SECTION: 1 - 20' (6 M) Coolant Zone, Spray Type System SIZING MILL: 3 - Driven Sizing Stands, with transmissions 3 - Idle Side Roll Units 1 - Straightener Unit (Modified Turkshead), Model 3XU 2- Idle Squaring Fixtures 1 - 40 HP, DC Motor and Reliance Electrical controls, 1150/1800 RPM 1 - Drive All 4 Speed Shift Box, Model DAS4, directly coupled to Drive Motor FLYING CUT-OFF: 1 - Abbey Etna, 2-Post Hydra-Shear 1 - Digital, Hydraulic Length Control System 1 - 20 Foot, Single Dump Run-Out-Table TOOLING: Several Sets of Tooling Available, to be Negotiated DRAWINGS: 1 - Complete set of Electrical and Mechanical drawings. All necessary Installation drawings. All necessary catalogs for all equipment purchased with this line. CONDITION: Very Good Reference 9990