For info:
SPECIFICATIONS: Material Rolled: Cold Reduced and Annealed Stainless Strip, All Grades Work Roll Diameter: 1.578" Maximum Work Roll Face: 27" 1st Intermediate Back-Up Roll Diameter: 2.8125" Maximum 2nd Intermediate Back-Up Roll Diameter: 5.031" Maximum Mill Drive Motor: 400 HP, 600/1200 RPM Gear Reduction Unit: Mill Drive, Ratio: 3.135 to 1 Rolling Speeds: 0 to 200 to 500 FPM Capacity: Strip Width: 10" Minimum 25" Maximum Maximum Gauge to Mill: .095" Minimum Gauge Finished: .005" Mill Equipment (1) Payoff Reel Paper Winder Motor: HP Unknown, Friction Clutch Controls Speed (1) 20" Diameter, 27" Face Payoff Reel Expanding Mandrel Type, Hydraulic Operation Equipped with Hydraulic Coil Positioning Buggy Reel Drive Motor: 25 HP, 650/1950 RPM Intermediate Gear Reduction Unit: Ratio 6.94 to 1 Reel is Connected to Drive by Flexible Disengaging Type Coupling (1) 5 Roll Straightener and Guide Stand Rolls: 3-1/2" Diameter, 27" Face Straightener Gear Reduction Unit: Ratio 6.95 to 1 Drive Motor: 25 HP, 650/1950 RPM (1) 20" Diameter, 26" Face Collapsible Tension Reel - Hydraulic Operation Reel Equipped with Hydraulic Coil Buggy and Stripper Plate (1) 20" Diameter, 27" Face, Solid Tension Reel Each Reel: Drive Motor: 125 HP, 250/100 RPM Coupled with a Magnetic Clutch Coupling to Maintain a Maximum Winding Tension of 16,000 Lbs. Reel Drive Gear Reduction Unit: Ratio 6.708 to 1 (1) O.H. Tramrail Crane (1) Fume Removal System (Vents to Outside) Electrical Equipment (1) 600 HP MG Set (General Electric) Motor: Synchronous Motor, 600 HP, 1200 RPM, 2400 Volts Generator: 400 KW, 1200 RPM (1) 400 HP, MG Set (General Electric) Motor: Synchronous Motor, 400 HP, 1200 RPM, 2400 Volts Generators: (2) 200 KW, 1200 RPM (1) 40 KW, 1200 RPM (1) 4 Section Metal Clad Synchronous Motor Starting Equipment (General Electric)