For info:
Age: 1973 SPECIFICATIONS: Maximum Tube Diameter: 3" Minimum Tube Diameter: 1/2" Maximum Wall Thickness: .125" Minimum D.T. Ratio: 10:1 Maximum Mill Speed: 300 FPM Spindle Diameter: 2.00" ENTRY EQUIPMENT: 1 - 10,000 Lb. Caldwell Coil Car With Tilt 1 - 6,000 Lb. Samco Double Uncoiler, Rebuilt in 1997 1 - KENT Shear End Welder, Model 10-135, Rebuilt in 1997 1 - KENT Floop Model R-22 With DC Drive Model R221-M-RE, 1988 FORMING MILL: 2 - Entry Guide Units 3 - Driven Breakdown Stands 4 - Pass Idle Cluster 3 - Driven Fin Passes 3 - Idle Side Roll Units Between Fins 1 - Lead Roll 1 - 3 Roll Weld Pressure 1 - Addison O.D. Scarfing Unit 1 - Scarfing Unit I.D. 1 - Iron Pass 1 - Forming Motor, 75 HP DC 1 - 9 Foot Coolant Zone, Flood-Type 1 - TMI-200 THERMATOOL 200 KW High Frequency Welder, 400 KC (1989) SIZING MILL: 1 - Oval Guide 3 - Driven Sizing Stands 3 - Idle Side Rolls 1 - 4 Roll Abbey Etna Turkshead 3 - Sizing Motors, 3-25 HP, DC Motors FLYING CUT-OFF 1 - ALPHA Model FR12-3-41, Serial No. 87 1 - Digital Length Control System 2 - Spare Single Cut-Dies 1 - 18' Run-Out Table NOTE: Alpha Cut-Off Was Rebuilt With Ortlinghouse Hydraulic Clutch, 1997. 2- Spare single cut die sets. TOOLING: 1-1/2", 1-3/4", 2", 2-1/4", 2-1/2", 3" Rounds EXIT LINE 1- DIECO Automatic Tube I.D. Scarfing wash out Machine 1- DIECO Double End Tube Dedimpling Machine, 2-Tubes at one time. 1- DIECO Automatic Tube Conveyor System 1- Deep Bed filter system with 2- 1200 Gallon Tanks SPARE PARTS: Approximately $75,000 in Spare Electrical & Mechanical