For info:
DO NOT QUOTE SPECIFICATIONS: Maximum Tube Diameter: 1-1/2" (38.1 mm) Minimum Tube Diameter: .375" (9.53 mm) Maximum Wall Thickness: .083" (2.1 mm) Minimum Wall Thickness: .018" (.46 mm) Maximum D/T Ratio: 60:1 Minimum D/T Ratio: 10:1 Maximum Material Yield: 50,000 PSI Maximum Mill Speed: 200 FPM (60 M) Roll Space Forming: 5" (127 mm) Roll Space Fin & Sizing: 3" (76.2 mm) Driven Spindle Diameter: 1.5 " (38.1 mm) Hand of Operation: Right to Left Date of Manufacture: Abbey Mill - 1971 Estimate ENTRY EQUIPMENT: 1 - Littell Double 2,500 Lb. Uncoiler, Pnuematic Brake 1 - Shear End Welder 1 - Looping System, Overhead Type, 400 Ft. of Strip Storage FORMING MILL: 1 - Entry Guide Unit 3 - Driven Breakdown Stands 4 - Idle Side Roll Units (Cluster unit, 4 pass) 2 - Driven Fin Stands 1 - Idle Side Roll Unit 1 - 10 HP DC Motor and Drive System 1 - Operators Control Station WELDING STATION: 1 - Seam Guide Lead Roll 2 - Roll Weld Pressure Unit 1 - Dual Scarfing Unit 1 - Bead Winder 1 - Abbey Etna, 100 KVA, Resistance Welder COOLANT SECTION: 1 - 6' Coolant Zone, Spray Type System SIZING MILL: 3 - Driven Sizing Stands 3 - Idle Side Roll Units 1 - Straightener Unit 1 - 10 HP DC Motors with Drive System FLYING CUT-OFF: 1 - Alpha, 3 Post Flying Cut-Off TOOLING: To Produce The Following: Round Sizes: .438" - .500" - .563" - .625" - .750" - .875" - .925" - 1.00" Square Sizes: 1/2" - 5/8" DRAWINGS: 1 - Complete set of Electrical and Mechanical drawings. All necessary Installation drawings. 1 - All necessary catalogs for all equipment purchased with this line. CONDITION: Very Good