For info:
SPECIFICATIONS: This system was designed to manufacture rings and rim material by rolling flat blanks into a formed shape, then weld the end seam, flash trim and size the finished product. Previous product 1-3/4" W x 1-1/4" Thick for ring gear blanks. #VPR-14 HY HAEUSLER Ring Roller, 4-Roll Type Serial Number: 10580-WD Age: 1980 With Correct Tooling Will Do The Following: Capacity: 4.209" Blanks: Minimum Diameter: 11" Maximum Diameter: 24.6" (For Larger Diameters Reconfigure Support Arms) Vertical Roll Adjustment: 5.7" - 6.49" Rolling Speed: 9 - 18 FPM EQUIPPED WITH: Hydraulic Power Supply Unit Central Control Console 340 KVA SCHLATTER #A24/340P Butt Welder Serial Number: S1-2018.0419 Age: 1980 Primary: 460 V, 1 Ph, 60 Hz - 50% Duty Cycle 220 V, 1 Ph, 60 Hz, 575/2350 Amps Secondary: 7.1 V, 34 KA EQUIPPED WITH: Hydraulic Clamping Hydraulic Upset 3 - Position Tap Switch (3) SCHLATTER Hydraulic Operation Flash Trimmers (To Trim All Sides Of Gear Blank Ring) EQUIPPED WITH: Hydraulic Clamping Hydraulic Stroke On Cutting Head 170 Ton ARROWSMITH Inverted Vertical Hydraulic Expander Age: 1970 Die Collapsed: 13" - 9-3/4" - 2 Steps Expansion Ratio: 15:1 Expansion Segments: 8 Expansion Diameter: 3/4" Approximate Expansion Length: 12" Stroke Upper Table Diameter: 33" 21" Maximum Diameter of Part on Work Holding Chuck Part Cycle Time: 28 Seconds NOTE: This is an inverted push up type expansion with 30" adjustment upward in vertical plane of work holding fixture with 3-jaw work holding fixture. Limit switch adjustment on expansion range. EQUIPPED WITH: 8 Segment Step Die To Size Ring Diameters of 11", 13", 14", & 16" Control Panel 50 HP Motor