For info:
UTREC NUMBER: 9849 MANUFACTURER: WEAN SPECIFICATIONS - Material: Steel Strip Thickness: .135" Max., .018" Min. Strip Width: 54" Trimmed, 60" Untrimmed max. Coil I.D.: 16" to 20" Incoming, 20" Outgoing Coil O.D.: 60" Max. Coil Weight: 30,000 Max. Shear Strength: 50,000 PSI Line Speed: 200 & 400 Bare Drum Material Thickness .135" = 5 Cuts Material Thickness .120" = 6 Cuts Material Thickness .105" = 7 Cuts Material Thickness .090" = 9 Cuts Material Thickness .075" = 14 Cuts Material Thickness .060" = 21 Cuts Material Thickness .018" = 21 Cuts Material Thickness .036" = 21 Cuts Material Thickness .018" = 21 Cuts Main Power: 575 V, 3 Phase, 60 Hertz CONSISTING OF: Entry Coil Car: 30,000 Lbs. x 60" O.D. x 60" Wide Capacity Pit Design w/Vee-Type Cradle Self-Contained Hydraulic System Mandrel Uncoiler with Hold Down Roll: Hydraulic Drum Expansion Accepts Coils Ranging from 16" to 20" I.D. w/4 Wedges on Each Mandrel. Drum is Four (4) Segment Design 65" Mandrel Face Hydraulic Sliding Base Wichita Air Operated Water-Cooled Brake Thread Drive is by a Hydraulic Motor & Clutch Arrangement through Chain & Sprockets Hold-Down Roll Mounted to Pay-Off Reel Coil Peeler: Pinch Roll Unit: Pinch Rolls Mounted on a Common Base w/Side Guides & Slitter 6.00" Dia. x 66" Roll Face Rolls Mounted in Roller Bearings Slitter Head: Slitter Mounted on a Common Base w/Pinch Roll Unit & Side Guide Unit Removable Base 3 Sets of Edge Guides Arbors are 7.50" Dia. x 62" Face and Accepts 13.00" Dia. Tooling Knife Adjustment by Manual Screw Actuation that is Cross-Connected to Both Arbor Housings Both Arbors Driven by Electric Gearmotor Scrap Winder: Recoiler with Overarm Seperator: Overhung Mandrel Design w/Manually Actuated Clamshell Delivers 20" I.D. Mults up to 60" O.D. without Lagging Hydraulic Push Off Drive is by a 50 HP Electric Motor through a Wer DC Clutch. 2 Speed Gear Box 26:1 & 52:1 Ratios Overarm Seperator Mounted to Recoiler Housing 2-Arm Turnstile: Manually Operated & Pinned at Various Increments to Accomodate the Unloading of Mults from Recoiler & Loading onto Exit Coil Car Exit Coil Car: L-shape Floor Mounted Design Vee-Cradle w/Non-Marking Top Self-Contained Hydraulic Unit Hydraulic Unit Water Cooling Unit Electrical: Four (4) Operator Stations, One Located at the Coil Car Pit, One Loacted at Coil Peeler, One at Slitter, and One at the Scrap Winder Tooling