Eurotech 730E Elite (2) Axis CNC Turning Center (2000) w/ IEMCA Bar Feed, 19.6" x 21.75" ,Fanuc 18iT

Eurotech 730E with IEMCA Bar Feed (2000)

Equipped with the following:

Fanuc 18iT CNC Control
Part catcher
Parts conveyor
Chip Conveyor
(12) Station Turret
Collet Chuck
Tailstock

Specifications:

Machining Capacity:
Maximum work length.........................................19.6"
Maximum turning length......................................17.6"
Maximum swing diameter......................................21.75"
Maximum facing diameter.....................................15"
Maximum turning diameter....................................12.18"

Main Spindle:
Spindle I.D. w/o draw tube..................................3.12"
Draw-tube capacity..........................................2.75"
Spindle speed...............................................40-4,000RPM
Variable speed steps........................................Direct drive
Spindle motor...............................................35HP
Motor type..................................................Wide range
Spindle nose................................................ASA A2-6

Turret:
Tool stations...............................................12
Maximum slide stroke (X axis)...............................8.6"
Rapid traverse rate (X axis)................................787 IPM
                    (Z axis)................................787 IPM
Maximum slide feed rate.....................................393 IPM
Turret indexing time........................................0.5 sec/pos.
Turret indexing type........................................bi-derectional
Hyfraulic clamping..........................................Curric coupling

Parts Catcher:
Maximum part diameter.......................................2.75"
Maximum part length (standard bucket).......................3.5"
Maximum part length (optional)..............................13"

Voltage required............................................220 volt AC, 3-phase
Air required................................................80 psi@4 CFM
Amperage Draw...............................................100 Amp.
Dimensions..................................................68.5"x68.5"x93.5"
Length of chip conveyor.....................................136"
Weight......................................................9,700lbs