For info:
S/N YEAR-1973 SPECIFICATIONS: STOCK # 108888 Maximum Swing Over Table.......................: 14 15/16" Nominal Distance Between Centers...............: 36" Maximum Distance Between Centers...............: 38 1/2" Distance From Floor To Center..................: 42 3/8" Swivel Table Graduated To An Angle: Toward Wheelhead...............................: 11 Degrees Away From Wheelhead............................: 3 Degrees Swivel Table Graduated To Taper Per Foot: Toward Wheelhead...............................: 4 1/2" Away From Wheelhead............................: 1 1/4" Grinding Wheelhead: Swivel Range: Lower Swivel, Right And Left...................: 90 Degrees Upper Swivel, Right And Left...................: 30 Degrees Grinding Wheel Sizes...........................: 14" x 1 1/2" x 5" Cross Feed: Automatic Infeed At Table Reversal (Diameter Reduction......................................: Low .0002" To .005", High .005"To .0125" Pick Feed Selections: Right End Only, Left End Only..................: Yes Right And Left Ends............................: Yes Wheelhead Movement/Turn Of Crossfeed Handwheel.: Low .050", High .250" Minimum Infeed Increment Diameter Reduction....: .000050" Headstock And Footstock: Taper Hole In Headstock And Footstock Spindles.: No. 9 B & S Number Of Work Rotation Speeds.................: Infinite Range Of Work Rotation Speeds..................: 50 To 500 RPM, (Footstock Center Retraction By Hand Lever) Headstock Spindle Nose, American Lathe Standard: 5" Headstock Swivel: Toward Wheellhead..............................: 90 Degrees Away From Wheelhead............................: 30 Degrees Table Traverse: Number Of Table Traverse Speeds................: Infinite Range Of Table Travese Speeds..................: 3 To 220 IPM Minimum Movement Required To Reverse Table.....: 3/32" Accuracy: Table Reversal At All TraverseRates..: .004" Independent Right Hand And Left Hand Tarry Adj.: 0 To 5 Seconds Mechanical Hand Table Traverse Per Revolution Of Handwheel...................................: Rapid 15/16", Slow 0.2" Equipped With: Adjustable Micro Table Stop With Starrett .001 Resolution Indicator Starrett .001 Resolution Table Taper Indicator Miscellaneous Parts Including: (1) Steady Rest, (1) Dresser (1) Radius Wheel Dresser Wrenches Guards Centers, Etc. Foot Pads Stand Alone Electrical Panel Motor Information: Wheelhead Motor...............................: 5 HP, 230/460 Volt, 1715 RPM-2 Grinding Speeds By Belt Change Hydraulic Pump Motor..........................: 1 1/2 HP, 230/460 Volt,1730 RPM Headstock Motor...............................: 1 1/2 HP, Vari Speed, 0-2700 RPM Cutting Fluid Pump Motor......................: 1/6 HP, 208/230/460 Volt (Currently Wired For 440 Volts) This Is A One Owner Machine With Original Scraping. It Was Used For Prototype Work, Never Used In Production. The Last Owner Had A Toolmaker Fashion An Internal Attachment. It Has Hinged Ears In Back Of The Spindle Where You Could Swing Down An Internal Attachment. He Had It Set Up To Do Internal Grinding With His Own Fixture. We Only Have The Dumore Spindle, But A Compentent Toolmaker Could Easily Make Another Attachment. This Cincinnati Universal Hydraulic Grinder Has Expensive Accessories Including The Table Mounted Universal Grinding Wheel Dresser. We Believe It Has Original Paint Copies Of Miscellaneous Books Included Electrical Print And Foundation Drawing In Panel Approximate Dimensions: 7' x 12' x 5' 6" H Approximate Weight: 11,500 Lbs.