Doosan-Daewoo Puma TT1500SY Dual Spindle Lathe

Doosan-Daewoo Puma TT1500SY Dual Spindle Lathe        
Year 2005
Manufacturer Doosan-Daewoo
Model Puma TT1500SY
Control: Fanuc 18iTT
 
Swing over carriage 9.05" 
Maximum turning diameter (upper turret) 9.05" 
Maximum turning diameter (lower turret) 9.05" 
Maximum bar capacity 2" 
Spindle: Chuck size 6" 
Spindle speed (RPM) 6,000 RPM 
Spindle nose ASA-A2-5 
Left spindle drawtube I.D. 2.047" 
Right spindle drawtube I.D. 2.047" 
Spindle bore diameter 2.44" 
AC high torque spindle motor (30 min.) 20 HP 
C-axis Minimum programmable angle (degrees) .001 L&R 
C-axis Rapid traverse rate (RPM) 600 L&R 
Turrets: Y-axis travel 3.93" (± 1.96") 
Y-axis rapid traverse rate 295 IPM 
X1 axis travel 6.5" 
X2 axis travel 7.48" 
Z1 axis travel 18.5" 
Z2 axis travel 19.29" 
Angle of slant bed 45 degrees 
X axis rapid traverse rate 787 IPM 
Z axis rapid traverse rate 1574 IPM 
Turret stations 12 + 12 
Tool holder type BMT 55P 
Turning tool shank size .75" 
Boring bar diameter 1.25" 
Tool selection Bi-directional 
Rotating tool RPM 5,000 RPM 
Rotating tool spindle motor (15 min rating) 7.5 Hp 
Rotating tool collet type ER-25 
Milling collet capacity .079" to .629" 
General: Coolant pump pressure 65 PSI 
Coolant pump motor 1.2 HP 
Coolant tank capacity 76 gallons 
Floor space 138" x 81" 
Net weight 16,535 lbs. 
Voltage required (3 phase) 205 - 235 volts 
Power requirement (Rated Capacity) 66 kVa 
Amps @ 200 Volts 188 
 
Equipped With: Fanuc 18iTT Control 
Chip conveyor, (2) Royal 3J collet chucks 
Full complement of static tool holders, a couple of live holders 
Comments: Job shop use 
4300 power on hours